December 3, 2020 by admin checkpoint 156-115.80 practice test Welcome to your checkpoint 156-115.80 practice test QUESTION 1 Which of the following is NOT a valid “fwaccel” parameter? A. stat B. stats C. templates D. packets None QUESTION 2 Which of the following would NOT be a flag when debugging a unified policy? A. rulebase B. clob C. connection D. tls None QUESTION 3 What is the shorthand reference for a classification object? A. CLOB B. class.obj C. classobj D. COBJ None QUESTION 4 Which “fwm” command syntax will instruct the gateway to load its most recent policy? A. fwm fetch localhost B. fwm –d fetchlocal C. fwm load -m D. None, as “fwm” can only be executed on management servers None QUESTION 5 Which is the correct “fw monitor” syntax for creating a capture file for loading it into WireShark? A. fw monitor –e “accept ; “andgt;> Output. cap B. This cannot be accomplished as it is not supported with R80.10 C. fw monitor –e “accept ;” –file Output.cap D. fw monitor –e “accept ;” –o Output. cap None QUESTION 6 Which one of the following does not belong to the initial status of a critical device? A. restart B. problem C. init D. ok None QUESTION 7 Fill in the blank. The tool ____________________ generates a R80 Security Gateway configuration report. A. infoCP B. infoview C. cpinfo D. fw cpinfo None QUESTION 8 Which command should be used to insert the fw monitor before the secxl_sync module? A. fw monitor –pi –secxl_sync –o capture. cap B. fw monitor –pl –secxl_sync –o capture. cap C. fw monitor –pO –secxl_sync –o capture.cap D. fw monitor –e “accept –pi –secxl_sync;” –o capture.cap None QUESTION 9 Which templates for SecureXL are not enabled by default? A. All templates are disabled by default B. Accept and NMR C. Drop and NAT D. All templates are enabled by default None QUESTION 10 The CPM process uses what ports? A. 19009 and 18120 B. 18265 and 257 C. 19009 and 9009 D. 18265 and 9009 None QUESTION 11 Which command is used to enable IPv6 on Security Gateway? A. set ipv6-state on B. add ipv6 interface on C. set ipv6-enable on D. set ipv6-state enabled None QUESTION 12 For organizations with existing IPv4 networks who wish to move to IPv6, which of the following is a Transition Mechanism that can be used? A. ipv4 to ipv6 Triple Stack B. Hex to Dec translation C. 6 in 4 Tunneling D. NAT-T to NAT6sec None QUESTION 13 Where will the command, “fw monitor -pi -VPN”, be inserted into the ctl chain? A. Before the Fw VM inbound B. Before the VPN module C. After the Fw VM outbound D. After the VPN module None Time's up
